《[中英文對照]柴油車排氣后處理裝置技術要求和試驗方法》由會員分享，可在線閱讀，更多相關《[中英文對照]柴油車排氣后處理裝置技術要求和試驗方法（14頁珍藏版）》請在裝配圖網上搜索。

1、中國汽車技術研究中心胡 毅2005年12月15日 一、背景 Background二、柴油車排氣后處理系統介紹 Diesel Aftertreatment System Introduction三、法規要求 Regulation Requirements四、技術方法 Technical Approach五、總結 Summary 1. 中國將于2007年1月1日執行滿足歐III排放的重型柴油機標準，2010年1月1日將執行滿足歐IV排放的重型柴油機標準（GB 17691-2005)。 China will require HD to meet Euro III emissions standard

2、s in 1/1/2007. Euro IV is planed for 1/1/2010 (GB 17691-2005)2. 基于現在的柴油機和柴油車技術，為滿足歐III和更嚴格的排放法規，加裝后處理系統是必需的。 Based on the current diesel engine and vehicle technologies, aftertreatment systems may be required in order to meet Euro III and above regulation requirements.3. 所有的后處理系統在裝車前，將進行測試和認證。 All a

3、ftertreatment systems will need to be tested and validated before they are equipped to the vehicles. l General test procedures will be required to test the candidate aftertreatment systems in order to meet the needs from all the engine and vehicle manufacturers.l Diesel aftertreatment technologies a

4、nd evaluation procedures exist in the leading markets in the US, Europe and Japan.l The draft procedures are being developed based on the existing procedures. 4. 必須制定切實可行的測試規程，來滿足所有發動機和車輛制造商的要求。 General test procedures will be required to test the candidate aftertreatment systems in order to meet th

5、e needs from all the engine and vehicle manufacturers.5. 在美國、歐洲和日本主要市場都有柴油車后處理技術和評價方法。 Diesel aftertreatment technologies and evaluation procedures exist in the leading markets in the US, Europe and Japan.6. 草案方法是在國際現有的測試規程上建立起來的。 The draft procedures are being developed based on the existing proced

6、ures. 主要的柴油機排放物PM、NOxMajor Diesel EmissionsPM and NOx控制PM的后處理系統Aftertreatment Systems To Control PM控制NOx的后處理系統Aftertreatment Systems To Control NOx 燃油催化劑 Fuel Borne Catalyst (FBC)可以和DPF結合在一起 May use together with DPF柴油氧化型催化劑（DOC） 只控制PM中的SOF排放 可以與DPF結合在一起Diesel Oxidation Catalyst (DOC) Only control S

7、OF in PMMay use together with DPF柴油顆粒過濾器（DPF）Diesel Particulate Filter (DPF)流通式Flow-through DPF, 25%部分流式Partial-flow DPF, 85%稀燃NOx 催化劑 Lean NOx Catalyst (LNC)大量降低燃油經濟性Greatly reduce fuel economy低的NOx轉化效率Low NOx efficiency (90%Selective Catalytic Reduction (SCR)Needs ureaHigh NOx efficiency, 90%稀燃NOx

8、捕集器或NOx吸收裝置（LNT）Lean NOx Trap (LNT) or NOx Absorber降低燃油經濟性；Reduce fuel economy高的NOx轉化效率；High NOx efficiency, 90%需要低硫柴油 Requires low sulfur diesel, 50ppm DOCHC, COSOF, O2(NO) H2O, CO2(NO2)LNTNOxHC N2H2O, CO2 SCRNOxNH3 N2DPFPM, O2(NO2) H2O, CO2(NO)Ultra Low Sulfur Diesel is RequiredAdditional HC is re

9、quired Urea System is Required 1. 柴油車后處理系統的性能是在發動機臺架上完成的。后處理系統包括DOC、DPF、SCR和LNT。 Performance of the diesel aftertreatment systems will be tested on engine dynomometer benches. The aftertreatment systems may include DOC, DPF, SCR, and LNT. 2. 后處理系統的性能評價將測試新鮮、預處理和老化后的轉化效率。 Performance evaluation will

10、test the aftertreatment system efficiencies at fresh, degreened, and aged aftertreatment systems.3. 熱機械耐久性能評價將測試熱振動，來模擬后處理系統在實車上的振動工況。 Thermal and mechanical durability evaluation will be performed on a hot-vibration table to simulate real-world vibration performance of the aftertreatments.評價后處理系統的多

11、種測試方法Several tests will be required to evaluate aftertreatment systems 4. 水急冷測試將評價整個后處理系統在極端工況下的封裝情況。 Water quench test will be performed to evaluate the whole aftertreatment system package under extreme operating conditions.5. 軸向推力測試將評價封裝性能。 Axial pressure test will be performed to evaluate the can

12、ning process.6. 密封性測試將評價整個后處理系統的封裝情況。 Leak check will be performed to evaluate the whole aftertreatment system package. 1. 所有的測試將在發動機臺架上進行。 All tests will be performed on engine bench2. 法規的主要焦點是放在柴油車排氣后處理系統的性能測試上。 所有的其他測試項目，包括水急冷、熱振動、軸向推力和密封性測試會與現有的汽油機TWC評價相類似。 The major focus of the regulation is d

13、iesel aftertreatment system performance test. All other tests, including water quench, vibration, axial pressure and leak check tests, will be similar to the approaches used for gasoline TWC evaluation. 3. 對于柴油車排氣后處理系統，預處理將在發動機臺架上進行，相當于實車6000公里，目的是使后處理催化劑達到穩定狀態。在發動機臺架上測試時，推薦采用25小時的預處理時間。 For diesel

14、aftertreatment systems, degreening will be performed on an engine bench to reflect real-world 6000km mileage in order for the aftertreatment catalyst to be stabilized. On engine bench test, 25-hour continuous operation is recommended for degreening.4. 輕型和重型柴油機/車輛的耐久性要求是不同的，詳細的規程見GB 18352.3-2005 (輕型)

15、, and GB *-* (重型，標準在制定中)。 The durability requirements for light-duty and heavy-duty diesel engines/vehicles will be different, and the specific requirements are presented at GB 18352.3-2005 (for light-duty), and GB *-* (for heavy-duty，regulation is in developing). 5. 詳細的方法見標準草案。 The detailed procedu

16、res are presented in the draft regulation.6. 以下是柴油車后處理系統性能測試的簡單介紹，包括： As a snapshot, the performance test of the diesel aftertreatment system will include: DOC:測試不同發動機工況下的HC、CO和PM（SOF）轉化效率。 DOC: to test conversion efficiency of HC, CO and PM (SOF) under different engine operating conditions. DPF:測試不

17、同發動機工況下PM轉化效率（過濾效率和再生效率），包括DPF 加載和再生工況。 DPF: to test conversion efficiency (filtration and regeneration efficiencies) of PM under different engine operating conditions. This will include DPF PM loading and regeneration operations. LNT:測試不同發動機工況下NOx的轉化效率。包括NOx吸收（在稀燃工況）和還原（在貧氧工況）。 LNT: to test convers

18、ion efficiency of NOx under different engine operating conditions. This will include NOx absorption (under lean conditions) and reduction (under rich conditions) operations. SCR:測試不同發動機工況下NOx的轉化效率。包括在需要工況下（穩態或循環工況）NH3或尿素的噴射。 SCR: to test conversion efficiency of NOx under different engine operating

19、conditions. This will include NH 3 or urea injection in a desired mode (steady-state or cyclic modes). 1. 草案包括了DOC、DPF、LNT 和 SCR 的評價方法，以滿足將來柴油車的排放法規。 DOC, DPF, LNT and SCR are included in this proposed regulation in order to meet the future diesel emissions regulations.2. 柴油機臺架將用來評價柴油車排氣后處理系統 的性能。 Engine bench tests will be performed to evaluate diesel aftertreatment system performance.3. 后處理系統的預處理和老化方法是建議的草案，標準還包括了系統的耐久性和整個后處理系統的測試。 Aftertreatment system degreening and aging procedures are proposed, and system durability and integrity are included in this regulation. 謝 謝！Thanks!